The Caleva Datastor ^TM

Collect and record operational data from extruders and spheronizers during all trial runs, automatically!

Automatically record experimental and operating parameters to your PC!

See graphical data during the experimental runs!

Two machines typically an extruder and a spheronizer) can be connected to the computer at the same time!

With the release of the new Datastor-2™ system Caleva extruders and spheronizers have (as an option) the ability to be connected by USB to a PC to record and store operational parameters.

The bench-top extruder or spheronizer is connected via USB to the PC then the following data is recorded:

• Power usage
• Operating speed in rpm
• Product temperature

The software can recognize and monitor up to two machines working independently at the same time.

Results can be opened by the Datastor software as a one page summary of all relevant data that can be printed as a permanent record. This enhances GLP and gives added quality assurance.

• A unique option that allow operators to connect an extruder and spheronizer direct to a PC.
• Easy and intuitive operation
• Data readings automatically taken every second.
• Permanent data storage on your PC without additional intervention.
• Simultaneous operation on two completely separate machines. This is normally one extruder and one spheronizer
• Results can be directly opened as a “read only” results sheet automatically.
• The Datastor™ cannot be retrofit and must be chosen at time of purchase.
• Other options are available for production machines